Axis Communications M7010 manual Unit connectors, Description, Function Pin

AXIS M7014/M7010 Installation Guide Page 15

Unit connectors

Network connector - RJ-45 Ethernet connector. Supports Power over Ethernet (PoE) Class 3 - max 12.95W. Using shielded cables is recommended.

Power input connector - 2-pin terminal block used for power input from the supplied power adapter or an external power supply.

The external power supply alternatives are:

1.	The Axis delivered PS-K P/N 34987 (AXIS M7014).
				1	2
2.	The Axis delivered PS-P P/N 42118 (AXIS M7010).
3.	An external 8-20 V DC limited power source with a maximum output current of 5A.
Function		Pin number	Description
GND		1	Ground
DC Power		2	Power input 8-20V DC
			max 7W (AXIS M7014)
			max 28W (AXIS M7010)

RS-485/RS-422 connector - Two 2-pin terminal blocks for RS-485/RS-422 serial interface used to control auxiliary equipment, e.g. PTZ devices.

The RS-485/RS-422 serial port can be configured to support:					RS-485/422
• Two-wire RS-485 half duplex
• Four-wire RS-485 full duplex
• Two-wire RS-422 simplex
• Four-wire RS-422 full duplex point to point communication				RX/TX				TX
				1		2	3		4
Function		Pin	Notes
RS-485/RS-422 RX/TX A		1	(RX) For full duplex RS-485/RS-422
			(RX/TX) For half duplex RS-485
RS-485/RS-422	RX/TX B	2
RS-485/RS-422	TX A	3	(TX) For full duplex RS-485/RS-422
RS-485/RS-422	TX B	4

microSD memory card slot - The microSD memory card can be used for local recording with removable storage.

BNC connector - Connect a 75 ohm coaxial video cable (max. length 800 feet (250 meters)).

Note: For each video input 75 Ohm video termination can be enabled/disabled via the product's web page at Video > Video Input > Video termination. These terminations are enabled on factory default. In cases

ENGLISH