AXIS M7014/M7010 Installation Guide | Page 7 |
Install the hardware
Important!
The casing of the AXIS M7014/M7010 is not approved for outdoor use - the product may only be installed in indoor environments.
Notes:
•The AXIS M7014/M7010 can simply be placed on a flat surface or mounted. See below for mounting instructions.
•Punch out the protective pads and stick them to the underside of the video encoder to prevent scratches on the surface where the video encoder is placed.
Mount the video encoder (AXIS M7014)
The video encoder is supplied with a mounting kit containing screws and plugs for mounting the video encoder to a concrete wall:
1.Place the video encoder against the wall, and mark the four mounting holes (see image on page 6).
2.Drill the four mounting holes.
3.Insert the provided wall plugs into the wall, and fasten the video encoder to the wall using the screws provided.
Mount the video encoder (AXIS M7010)
The video encoder is supplied with a mounting kit containing brackets and screws. The unit can be mounted in a rack or on a wall.
After removing the existing 4 screws, attach the mounting bracket to the video encoder at an angle suitable for installation in a standard 1U 19” rack, or on the wall.
| AXIS M7010 in rack | AXIS M7010 on wall |
Group 1 | Group 2 Group 3 | Group 4 |
|
| Mounting bracket |
ENGLISH
Bracket position for rack mount
This side up
Bracket
This side up
Bracket position for wall mount
This side up 
