Page 8 | AXIS M7014/M7010 Installation Guide |
Note: Each bracket must be attached to the appropriate side of the video encoder, and at an appropriate angle depending on whether it is mounted on the wall or in the rack.
Mounting on wall
1.Position the video encoder against the wall with the brackets attached, and mark the four mounting holes for each bracket (see image above).
2.Drill the four mounting holes.
3.Fasten the video encoder to the wall using appropriate screws.
Connect the cables
1.Connect the encoder to the network using shielded network cables. If using PoE see note below.
2.Connect the cameras to the video inputs.
3.If powering the unit with DC input, connect the supplied indoor power adapter or an external power supply. See note below.
4.Check that the indicator LEDs indicate the correct conditions. See the table on page 16 for further details.
Note: The unit can be powered using either the DC power input or PoE.
If powering the unit using DC power, connect the power supply to the power connector at the rear of the unit.
If powering the unit using PoE, connect a PoE network cable. For AXIS M7010, connect 4 PoE network cables (one for each group).
