Axis Communications P5544 Storage

AXIS P5544 PTZ Dome Network Camera

System Options

The following traps are available:

•Coldstart

•Warmstart

•Linkup

• Authentication failed

SNMP v3 provides encryption and secure passwords. To use traps with SNMP v3, an SNMP v3 management application is required.

To use SNMP v3, HTTPS must be enabled, see HTTPS, on page 39. To enable SNMP v3, check the box and provide the initial user

password.

Note

The initial password can only be set once. If the password is lost, the Axis product must be reset to factory default, see

Reset to Factory Default Settings, on page 49.

UPnPTM

The Axis product includes support for UPnPTM.UPnP

TM is enabled by default and the product is automatically detected by operating

systems and clients that support this protocol.

UPnPTM can be disabled under System Options > Network > UPnPTM.

The RTP port range and multicast settings are conﬁgured under System Options > Network > RTP.

The RTP port range deﬁnes the range of ports from which the video/audio ports are automatically selected. For multicast streams,

only certain IP addresses and port numbers should be used.

Select Always Multicast Video and/or Always Multicast Audio to start multicast streaming without opening an RTSP session.

The Axis product includes support for Bonjour. Bonjour is enabled by default and the product is automatically detected by operating

systems and clients that support this protocol.

Bonjour can be disabled under System Options > Network > Bonjour.

Storage

NOTICE

To prevent corruption of recordings, the SD card should always be unmounted before it is ejected.

Important

ToaccesstheSDcard,thetopcovermustberemoved.Afterremounting the alignment of the lens may differ slightly

and the PTZ mechanics should be recalibrated. Go to System Options > Maintenance and click Calibrate PTZ.Formore

information, see PTZ Calibration, on page 47.

The Axis product supports SD cards with the following ﬁle systems:

•ext4 — recommended due to its resilience against data loss if the card is ejected or if there is abrupt power loss. To access

data stored on the card from the Windows operating system, a third-party ext4 driver or application is required.

•vFAT — most SD cards are pre-formatted with vFAT when purchased.