Axis Communications ptz dome network camera user manual Hardware overview, Connectors

AXIS P5532 PTZ Dome Network Camera

Hardware overview

Hardware overview

4 5 6 7

1 3

2

1Part number (P/N) & Serial number (S/N)

2Network connector (High PoE)

3Multi-connector

4Control button

5SD memory card slot

6Status LED indicator

7Restart button

Connectors

Network connector - RJ-45 Ethernet connector. Supports Power over Ethernet Plus (PoE+) IEEE 802.3at. Use the supplied midspan.

Caution

Due to local regulations or the environmental and electrical conditions in which the product is to be used, a shielded network cable (STP) may be appropriate or required. Any network cables that are routed in outdoor environments or similar shall be shielded (STP) and intended for their specific use. Make sure that the midspan is properly grounded. See Electromagnetic Compatibility (EMC) for regulatory requirements.

SD card slot - A standard or high-capacity SD card (not included) can be used for local recording with removable storage. For instructions on how to insert and remove an SD card, please refer to the Installation Guide.

Note

Before removal, the SD card should be unmounted to prevent corruption of recordings. To unmount the SD card, go to Setup > System Options > Storage > SD Card and click Unmount.

Control button - The control button is used for:

•Connecting to an AXIS Video Hosting System service. See page 40. To connect, press and hold the button for about 1 second until the Status LED flashes green.

5