Installation and Operation, cont’d
C
D
Connected | MTP |
Device Pins | Pins |
Receive | Tx |
Transmit | Rx |
Ground | Gnd |
TP cable termination
N
Figure
Figure 2-4 — RS-232 connector wiring
NBy default, the
E | |
| output to correct for long cable runs. See the table on page |
| for suggested switch settings based on the transmitted video |
| format and transmission distance. |
F Transmitter Output connector — Connect one end of a TP cable |
Side Pins:
1 2 3 4 5 6 78
Insert
Twisted
Pair Wires
Connector
| T568A | T568B |
|
Pin | Wire color | Wire color | Signal |
1 | Red+/V. sync+ | ||
|
|
|
|
2 | Green | Orange | |
|
|
|
|
3 | Mono audio+ | ||
|
|
|
|
4 | Blue | Blue | Green+ |
|
|
|
|
5 | Green– | ||
|
|
|
|
6 | Orange | Green | Mono audio– |
|
|
|
|
7 | Blue+/H. sync+ | ||
|
|
|
|
8 | Brown | Brown | |
|
|
|
|
NOTE If you are using Enhanced
to this |
CDo not connect this device to a computer data or telecommunications network.
Connect the free end of the same TP cable from the transmitter to the receiver’s Input
See “TP cable termination” on the next page to properly wire the
Figure 2-5 — TP cable termination
NEnhanced
The green, brown, and blue pairs of this cable have virtually identical lengths and should be used to transmit the RGB signals.
The orange pair of this cable has a different length and should not be used to transmit the RGB signals.
MTP 4T 15HD RS • Installation and Operation | MTP 4T 15HD RS • Installation and Operation |