![Introduction](/images/new-backgrounds/15419/1541911x1.webp)
Introduction
CDo not connect this device to a computer data or telecommunications network.
About the MTP 4T 15HD RS
The Extron MTP 4T 15HD RS consists of four MTP T 15HD RS transmitters in a single enclosure. This set of transmitters and the Extron MTP RL 15HD RS and MTP RL 15HD RS SEQ receivers provide a means to distribute VGA or other high resolution video and
The MTPs transmit and receive over Extron’s Enhanced Skew- Free A/V UTP cable or over CAT 5, 5e, or 6 shielded twisted pair (STP), unshielded twisted pair (UTP), or foil shielded twisted pair (FTP) cable.
The MTP 4T 15HD RS can support four transmitter/receiver systems. Each system requires a transmitter and at least one connected compatible MTP receiver. Additional receivers can be daisy chained.
NIn this manual the term "transmitter assembly" refers to the MTP 4T 15HD RS.
Each of the MTP transmitters in the assembly inputs a set of high resolution or low resolution video signals (RGB, component video,
Each receiver inputs the transmitted proprietary signal on an
The
•Can be bidirectional in each system that consists of just one receiver (not a daisy chain); that is, the receiver can receive commands from the transmitter and pass
NBy default, the
•Supports software flow control (XON, XOFF).
NHardware flow control is not supported.
•Supports full duplex and half duplex operation.
•Supports any baud rate (up to 38,400), data bits, parity, stop bits, and data format without configuration.
NHigher rates are possible, but performance will vary as a function of baud rate and TP cable length.
Up to eight receivers can be connected in series to a single transmitter, provided that the total distance from the transmitter’s TP output to the last receiver in the chain does not exceed the recommended distance for the resolution being used.
NEach individual transmitter provides
The SEQ version of the receiver also corrects the skew delay (misconvergence) commonly encountered when using CAT 5, 5e, or 6 TP cables for RGB video and component video transmission.
NAn SEQ receiver should not be necessary when Extron Enhanced
All four transmitters in the MTP 4T 15HD RS are powered by a single internal 100 VAC to 240 VAC, 50/60 Hz, 20 watts power supply that provides worldwide power compatibility.
MTP 4T 15HD RS • Introduction | MTP 4T 15HD RS • Introduction |