AXIS Q6044-C PTZ Dome Network Camera

Multi-Connector Cable

Multi-Connector Cable

The supplied multi-connector cable is required in order to maintain the camera’s IP rating.

The multi-connector cable is connected to the camera’s multi-connector, see Hardware Overview on page 6 . The wires are connected to the supplied media converter switch, see Media Converter Switch on page 8 . The cable provides the following signals:

• DC power to camera

• Network (Ethernet 10/100Base-T)

• Input/Output (I/O)

Function

Pin – wire

Notes

Specifications

 

 

 

 

Configurable (Input

2 – blue

Digital input – Connect to pin 8 to activate, or

0 to max 30 V DC

or Output)

7

– yellow

leave floating (unconnected) to deactivate.

 

 

 

 

 

 

 

 

 

Digital output – Connected to pin 1 when

0 to max 30 V DC, open

 

 

 

activated, floating (unconnected) when

drain, 100 mA

 

 

 

deactivated. If used with an inductive load, e.g. a

 

 

 

 

relay, a diode must be connected in parallel with

 

 

 

 

the load, for protection against voltage transients.

 

 

 

 

 

 

RX+

3

– green/white

Ethernet – receiving

 

 

 

 

 

 

RX-

4

– green

Ethernet – receiving

 

 

 

 

 

 

TX+

5

– orange/white

Ethernet – transmitting

 

 

 

 

 

 

TX-

6

– orange

Ethernet – transmitting

 

 

 

 

 

 

0 V DC (-)

8

– black

 

0 V DC

 

 

 

 

DC output (12 V)

1, 9 – red

Used to power camera

12–13.2 V DC

 

 

 

 

Max load = 6 A

 

 

 

 

 

57

Page 57
Image 57
Axis Communications Q6044-C Multi-Connector Cable, Function Pin wire Specifications, Green/white Ethernet receiving