English

Installation

Turn the water off at the main, or at the stops, before beginning.

Cut the plaster shield so that it extends 1/16” outside the surface of the finished wall.

Seal the wall around the i-box with waterproof sealant.

Failure to seal the wall can lead to possible water damage.

Remove the label. Cut the support arms that connect the flushing plug to the installation box. Remove the flushing plug. Do not discard the screws.

Be sure to remove the blue flushing plug sealing gasket.

Failure to remove the gasket can result in damage to the cartridge and possible water damage.

Insert the cartridge in the rough. Make sure that the locator tab on the cartridge goes straight into the notch in the rough.

Use the flushing plug screws to connect the cartridge retainer plate to the rough. Tighten the screws evenly, using a manual screwdriver, in a cross-wise pattern. Do not overtighten the screws.

notch

locator

tab

Page 7
Image 7
Axor 06064XX0 installation instructions English Installation, Notch, Tab