Installation -- Flat Wall
Wrap the threads on the supply nipples with Teflon thread tape.
Install the enclosed elbows so that the outlets face upwards.
Measure up the wall 78 ¾”, making sure that the line is plumb. Mark the position for the top screw hole.
From the position of the top screw hole, measure down 35 3/8”. Mark the position for the center screw hole.
From the center screw hole, measure down 19 1/8”. Mark the position for the bottom screw hole.
Use a 6 mm drill bit suitable for the wall surface. Drill the three screw holes.
Install the anchors. Seal the wall around the anchors with waterproof sealant.
Install the set screws in the top and bottom holes.
Use a 10 mm nut driver to attach a nut to the top set screw.
Slide the panel over the top and bottom set screws.
Tighten the nut on the top set screw.
Install and tighten the nut on the bottom set screw.
Install one recessed head screw and the large washer on the center hole. Tighten the screw.
5 |
