Dell 36XX, 34XX, 38XX, 32XX manual Reset Storage Array Battery Install Date, SampleType is all

Parameter	Description
sampleType	This parameter is optional. The default value for
	sampleType is all.
	• all—Data for all three sample types are reset.
	• mostRecent—Statistics are reset for the most
	recent 50 resynchronization samples.
	• longestSyncTime—Statistics are reset for the
	most recent 20 longest resynchronization
	samples.
	• errors—Statistics are reset for the most recent
	20 failed resynchronization samples.

Notes

Statistics are reset for replicated virtual disks in the Primary role. The statistics that are reset include the following data:

•Synchronization start time

•Synchronization type (manual or periodic)

•Synchronization duration

•Number of bytes sent

•Maximum and minimum write time (for a single write)

•Maximum and minimum synchronization data rate

•Total write time

•Repository utilization (%)

•Recovery point age

Reset Storage Array Battery Install Date

Description

This command resets the age of the batteries in a storage array to zero days. You can reset the batteries for an entire storage array or just the battery for a specific RAID controller module or in a specific battery pack.

Syntax

reset storageArray batteryInstallDate controller=(0 1)

Parameter

Parameter	Description
controller	Specifies the RAID controller module that contains
	the battery for which to reset the age. Valid RAID
	controller module identifier values are 0 and 1. The
	identifier value is 0 for the RAID controller module
	on the top and 1 for the RAID controller module
	on the bottom when viewed from the rear of the

259