Dell 32XX, 34XX, 38XX, 36XX manual Test Snmp Trap Destination, TrapReceiverIP

Parameter Description

path. The connectivity test sends an inter-RAID controller module message between the storage arrays, and then validates that the corresponding remote replication group on the remote storage array exists. It also validates that the virtual disk members of the remote replication group on the remote system match the virtual disk members of the remote replication group on the local system.

• Latency—Sends a SCSI test unit command to each virtual disk on the remote storage array associated with the remote replication group to test the minimum, average, and maximum latency.

• Bandwidth—Sends two inter-RAID controller module messages to the remote storage array to test the minimum, average, and maximum bandwidth as well as the negotiated link speed of the port on the RAID controller module performing the test.

• Port connections—Shows the port that is being used for replicating on the local storage array and the port that is receiving the replicated data on the remote storage array.

Test SNMP Trap Destination

Description

This command tests the connection and identification of the trap receiver for a specific Simple Network Management Protocol (SNMP) community. This command tests the trap destination by sending a trap message to the trap receiver.

Syntax

start snmpTrapDestination trapReceiverIP=ipAddress communityName="communityName"

Parameters

Parameter	Description
trapReceiverIP	The IP address of the SNMP manager to which you
	want to send trap messages.
communityName	The name of the SNMP community for which you
	want to send trap messages.

410