Dell 32XX, 34XX VirtualDisk or virtualDisks name, CacheFlushModifier, CacheWithoutBatteryEnabled

Parameters

Parameter	Description
allVirtualDisks	Specifies the properties for all virtual disks in the
	storage array.
virtualDisk or virtualDisks (name)	Specifies the name of the virtual disk for which to
	define properties. You can enter more than one
	virtual disk name if you use the virtualDisks
	parameter. You must put quotation marks (" ") and
	brackets ([ ]) around the virtual disk name. The
	virtual disk name and quotation marks must be
	inside the brackets.
virtualDisk	Specifies the WWID of the virtual disk for which
	you are setting properties. You can use the WWID
	instead of the virtual disk name to identify the
	virtual disk. You must put angle brackets (< >)
	around the WWID.
	NOTE: When running this command, do not
	use colon separators in the WWID.
cacheFlushModifier	The maximum amount of time that data for the
	virtual disk stays in cache before the data is flushed
	to physical storage. Valid values are listed in the
	Notes section.
cacheWithoutBatteryEnabled	The setting to turn on or turn off caching without
	batteries. To turn on caching without batteries, set
	this parameter to TRUE. To turn off caching
	without batteries, set this parameter to FALSE.
mediaScanEnabled	The setting to turn on or turn off media scan for
	the virtual disk. To turn on media scan, set this
	parameter to TRUE. To turn off media scan, set this
	parameter to FALSE. (If media scan is disabled at
	the storage array level, this parameter has no
	effect.)
mirrorCacheEnabled	The setting to turn on or turn off the replication
	cache. To turn on the replication cache, set this
	parameter to TRUE. To turn off the replication
	cache, set this parameter to FALSE.
modificationPriority	The priority for virtual disk modifications while the
	storage array is operational. Valid values are
	highest, high, medium, low, or lowest.
owner	The RAID controller module that owns the virtual
	disk. Valid RAID controller module identifiers are 0
	or 1, where, 0 is the RAID controller module in slot
	0, and 1 is the RAID controller module in slot 1. Use

330