Dell 32XX, 34XX, 38XX, 36XX manual SyncInterval, Run the resume remoteReplicationGroup

Parameter	Description
syncInterval	Specify the length of time between automatically
	sending updates of modified data from the local
	storage array to the remote storage array. You can
	specify the length of time in minutes, hours, or
	days.
warningSyncThreshold	Specify the length of time to wait until a warning is
	triggered for cases in which the synchronization of
	all of the virtual disks within the remote replication
	group takes longer than the defined time. You can
	specify the length of time in minutes, hours, or
	days.
warningRecoveryThreshold	Specify the length of time to wait until a warning is
	triggered when the automatic data update for the
	point-in-time image on the remote storage array is
	older than the defined time. Define the threshold
	from the end of the previous update. You can
	specify the length of time in minutes, hours, or
	days.
	NOTE: You must set the Recovery Point
	Threshold to be twice as large as the
	synchronization interval threshold.
warningThresholdPercent	Specify the length of time to wait until a warning is
	triggered when the capacity of a replication
	repository virtual disk reaches the defined
	percentage. Define the threshold by percentage
	(%) of the capacity remaining.
autoResync	The settings for automatic resynchronization
	between the primary virtual disks and the
	secondary virtual disks of a remote replicated pair
	within a remote replication group. This parameter
	has these values:
	• enabled—Automatic resynchronization is
	turned on. You do not need to do anything
	further to resynchronize the primary virtual disk
	and the secondary virtual disk.
	• disabled—Automatic resynchronization is
	turned off. To resynchronize the primary virtual
	disk and the secondary virtual disk, you must
	run the resume remoteReplicationGroup
	command.

Notes

•The Remote Replication premium feature must be enabled and activated on the local and remote storage arrays that will be used for replication activities.

•You can use any combination of alphanumeric characters, hyphens, and underscores for the names. Names can have a maximum of 30 characters.

186