Dell 36XX, 34XX, 38XX, 32XX manual FileSystem

Parameter	Description
	fileSystem	This option checks the
		structural integrity of the
		database.
	replication	•	When the
			sourceLocation
			parameter is set to disk,
			the peer RAID controller
			module initiates a block
			check.
		•	When the
			sourceLocation
			parameter is set to
			cache, the peer RAID
			controller module
			initiates a record check.
	contentCheck	This option performs a deep
		analysis of each record's
		contents.
	The default value is fileSystem.
controller	The RAID controller module that has the database
	on which you want to run the diagnostic tests.
	Valid RAID controller module identifiers are 0 or 1,
	where 0 is the RAID controller module in slot 0,
	and 1 is the RAID controller module in slot 1.

Enclose the RAID controller module identifier in square brackets ([ ]).

Notes

This command runs a consistency check against a configuration database. All database records are checked. Error data is written to a file in the data folder on disk automatically. You do not need to specify an output file.

NOTE: Executing a consistency check with the diagnosticType parameter set to a value other than filesystem, and with the sourceLocation parameter set to onboard, can cause the operation to run for a long time. This can have adverse effects on host I/O processing. This operation should be done only under direction from the support organization.

Upon completion of the diagnostic test, the RAID controller firmware returns one of these results:

•Diagnosis completed without errors. No ZIP file created.

•Diagnosis completed with errors. Refer to the ZIP file created at:

...\Install_dir\data\FirmwareUpgradeReports\timestamp_buildNo.zip

If the diagnostic test detects an inconsistency in the configuration database, the RAID controller module firmware performs these actions:

•Returns a description of the inconsistency

391