Dell 34XX, 38XX, 32XX, 36XX manual PhysicalDiskCount, DiskGroupUserLabel

[usageHint=(fileSystem dataBase multiMedia)] [enclosureLossProtect=(TRUE FALSE)] [drawerLossProtect=(TRUE FALSE)] [dssPreAllocate=(TRUE FALSE)] [securityType=(none capable enabled)] [dataAssurance=(none enabled)]

Parameters

Parameter	Description
physicalDiskCount	Number of unassigned physical disks to use in the disk group.
	NOTE: The physicalDiskCount parameter enables you
	to choose the number of physical disks to use in the disk
	group. You do not need to specify the physical disks by
	enclosure ID and slot ID. The RAID controller modules
	choose the specific physical disks to use for the disk group.
diskGroupUserLabel	The alphanumeric identifier (including – and _) that you want to
	give the new disk group. Enclose the disk group identifier in
	double quotes (" ").
raidLevel	RAID level of the disk group that contains the virtual disk. Valid
	values are 0, 1, 5 or 6.
userLabel	Name to give to the new virtual disk. You must put quotation
	marks (" ") around the new virtual disk name.
physicalDiskType	Specifies the type of physical disk to use in the virtual disk. You
	cannot mix physical disk types in the virtual disk. The valid
	physical disk type is SAS.
capacity	The size of the virtual disk that you are adding to the storage
	array. Size is defined in units of bytes, KB, MB, GB, or TB.
	NOTE: A space must be added between the last digit and
	the size (bytes, KB, MB, or GB) for values greater than 9. If
	you do not specify a capacity, all the available physical disk
	capacity in the disk group is used. If you do not specify the
	capacity unit, bytes is used as the default unit.
owner	The RAID controller module that owns the virtual disk. Valid
	RAID controller module identifier values are 0 and 1. The
	identifier value is 0 for the RAID controller module on the top
	and 1 for the RAID controller module on the bottom when
	viewed from the rear of the enclosure. If you do not specify an
	owner, the RAID controller module firmware determines the
	owner.
	NOTE: The owner parameter defines which RAID controller
	module owns the virtual disk.
cacheReadPrefetch	The setting to turn on or turn off cache read prefetch. To turn
	off cache read prefetch, set this parameter to FALSE. To turn on
	cache read prefetch, set this parameter to TRUE.

172