Dell 32XX Set Host Channel, Set hostChannel hostChannelNumber preferredID=portID, HostChannel

Host Group Parameter	Host Has Individual Virtual Disk-	Host Does Not Have Individual
	to-LUN Mappings	Virtual Disk-to-LUN Mappings
	under the new host group	under the new host group
	defined by hostGroupName.	defined by hostGroupName.
none	The host is removed from the	The host is removed from the
	host group as an independent	present host group and is placed
	partition and is placed under the	under the default group.
	root node.
defaultGroup	The command fails.	The host is removed from the
		present host group and is placed
		under the default group.

NOTE: When you use this command, you can specify one or more of the optional parameters. You do not, however, need to use all of the parameters.

NOTE: You can use any combination of alphanumeric characters, hyphens, and underscores for the names. Command names can have a maximum of 30 characters. If you exceed the maximum character limit, replace square brackets ([ ]) with angle brackets (< >) to overcome this limitation.

Set Host Channel

Description

This command defines the loop ID for the host channel.

Syntax

set hostChannel [hostChannelNumber] preferredID=portID

Parameters

Parameter	Description
hostChannel	The identifier number of the host channel for
	which you want to set the loop ID.
	The host channel identifier number is constructed
	by combining the RAID controller module number
	and the host channel number. Enclose the host
	channel identifier number in square brackets ([ ]).
	Separate the RAID controller module number from
	the host channel number with a comma.
	For example, the identifier number for host
	channel 2 on RAID controller module 0 would be
	[0,2].
preferredID	The port identifier for the specified host port. Port
	ID values are 0 to 127.

294