Dell 38XX, 34XX, 32XX, 36XX manual Set Storage Array Learn Cycle, Set Storage Array Redundancy Mode

Set Storage Array Learn Cycle

Description

This command sets the learn cycle for the battery backup unit. The learn cycle enables the MD storage management software to predict the remaining battery life. Learn cycles run at set intervals and store the results for software analysis.

Syntax

set storageArray learnCycleDate (daysToNextLearnCycle=numberOfDays day=dayOfTheWeek) time=HH:MM

Parameters

Parameter	Description
daysToNextLearnCycle	Valid values are 0 through 7, where, 0 is
	immediately and 7 is in seven days. The
	daysToNextLearnCycle parameter takes place
	up to seven days after the next scheduled learn
	cycle.
day	Valid values for the day parameter include the days
	of the week. Setting the day causes the next learn
	cycle to be scheduled on the specified day, after
	the currently scheduled learn cycle.
time	The time in 24-hour format; for example 8:00 a.m.
	is entered as 08:00. Nine o’clock p.m. is entered as
	21:00, and 9:30 p.m. is entered as 21:30.

NOTE: You can set the learn cycle to occur only once during a seven-day period. The time parameter selects a specific time that you want to run the learn cycle. If a value is not entered, the command uses a default value of 00:00 (midnight). If the day and time specified are in the past, the next learn cycle takes place on the next possible day specified.

Set Storage Array Redundancy Mode

Description

This command sets the redundancy mode of the storage array to either simplex or duplex.

Syntax

set storageArray redundancyMode=(simplex duplex)

325