Dell 34XX Set Disk Group Forced State, Set Disk Pool, Set diskGroup diskGroupName forcedState

operation, stripe size, and whether replication is enabled may result in less memory being available to complete the DCE operation. In such a scenario, try each of the options below and retry the operation:

•Create the required disk group size using other unassigned physical disks.

•Delete the current disk group and then recreate the disk group with the desired number of physical disks.

•Reduce the segment size being used and then retry the operation.

Set Disk Group Forced State

Description

This command moves a disk group into a Forced state. Use this command if the start diskGroup import command does not move the disk group to an Imported state or if the import operation does not work because of hardware errors. In a Forced state, the disk group can be imported, and you can then identify the hardware errors.

Syntax

set diskGroup [diskGroupName] forcedState

Parameters

Parameter	Description
diskGroup	Sequence number of the disk group for which to
	set properties. You must put brackets ([ ]) around
	the disk group number.

NOTE: You can move the physical disks that comprise a disk group from one storage array to another storage array. The CLI provides three commands that let you move the physical disks. The commands are start diskGroup export, start diskGroup import, and set diskGroup forcedState. In the Forced state, you can perform an import operation on the disk group.

Set Disk Pool

Description

This command sets the attributes associated with a disk pool based on the specified parameters.

Syntax

set (diskPool [diskPoolName] diskPools [diskPoolName1... diskPoolNamen] allDiskPools) [reservedPhysicalDiskCount=reservedPhysicalDiskCountValue] [warningThreshold=(warningThresholdValue default)] [criticalThreshold=(criticalThresholdValue default)] [criticalPriority=(highest high medium low lowest)] [degradedPriority=(highest high medium low lowest)] [backgroundPriority=(highest high medium low lowest)] [userLabel=diskPoolName]

288