Dell 34XX, 38XX, 32XX, 36XX manual Ssid

	enclosure ID values, the drawer ID values, and the
	slot ID values insqurare brackets ([ ]).
diskGroup	The name of an existing disk group in which you
	want to create the virtual disk. (To determine the
	names of the disk groups in your storage array, run
	the show storageArray profile command.)
newDiskGroup	The name that you want to give a new disk group.
	Enclose the new disk group name in double
	quotation marks (" ").
userLabel	The name of the virtual disk that you want to
	recover. The user label has two parts:
	• The virtual disk name. Enclose the virtual disk
	name in double quotation marks (" ").
	• The world wide name of the virtual disk,
	virtualDiskWWN, in the form of a 16 byte
	identifier, for example,
	60080E500017B4320000000049887D77.
	Enclose the identifier in double quotation
	marks (" ").
	You must enter both the virtual disk name and the
	world wide name of the virtual disk. You must
	enter the virtual disk name first.
	For example: userLabel="engdata"
	virtualDiskWWN=60080E500017B432000000004
	9887D77
capacity	The size of the virtual disk that you are adding to
	the storage array. Size is defined in units of bytes,
	KB, MB, GB, or TB.
offset	The number of blocks from the start of the disk
	group to the start of the referenced virtual disk.
raidLevel	The RAID level of the disk group that contains the
	physical disks. Valid values are 0, 1, 5, or 6.
segmentSize	The amount of data (in KB) that the RAID controller
	module writes on a single physical disk in a disk
	group before writing data on the next physical disk.
	Valid values are 8, 16, 32, 64, 128, 256, or 512.
dssPreallocate	The setting to turn on or turn off allocating virtual
	disk storage capacity for future segment size
	changes. To turn on allocation, set this parameter
	to TRUE. To turn off allocation, set this parameter
	to FALSE.
SSID	The storage array subsystem identifier of a virtual
	disk. Use the show virtual disk command to
	determine the storage array subsystem identifier.

236