Dell 32XX, 34XX, 38XX, 36XX manual Start Remote Replication Synchronization

Parameter Description

ID values are 0 to 31. You must put brackets ([ ]) around the enclosure ID value and slot ID value.

Start Remote Replication Synchronization

Description

This command starts Remote Replication synchronization.

Syntax

start asyncRemoteReplicationGroup ["asyncRemoteReplicationGroupName"] synchronize [deleteRecoveryPointIfNecessary]

Parameter

Parameter	Description
asyncRemoteReplicationGroup	The name of the remote replication group for
	which you want to start synchronization. Enclose
	the remote replication group name in double
	quotation marks (" ") inside square brackets ([ ]").
deleteRecoveryPointIfNecessary	The parameter to delete the recovery point if the
	recoverable synchronization data has exceeded
	time threshold for recovery. Recovery point age is
	measured from the time the data was frozen on
	the primary storage array.

Start Remote Replication (Legacy) Synchronization

Description

NOTE: This command valid only with Fibre Channel storage arrays.

This command starts Remote Replication (legacy) synchronization.

Syntax

start remoteReplication primary [”virtualDiskName”] synchronize

Parameters

Parameter	Description
primary	The name of the primary virtual disk for which you
	want to start synchronization. Enclose the primary
	virtual disk name in double quotation marks (“ ”)
	inside square brackets ([ ]).

386