Dell 32XX Set Snapshot Group Attributes, PerformanceMonitorInterval, PerformanceMonitorIterations

Parameter	Description
performanceMonitorInterval	The frequency of gathering performance data.
	Enter an integer value for the polling interval, in
	seconds, for which you want to capture data. The
	range of values is 3 to 3600 seconds. The default
	value is 5 seconds.
performanceMonitorIterations	The number of samples to capture. Enter an
	integer value. The range of values for samples
	captured is 1 to 3600. The default value is 5.

Additional Information

When you use this command, you can specify one or more of the optional parameters.

Passwords are stored on each storage array in a management domain. If a password was not previously set, you do not need a password. The password can be any combination of alphanumeric characters with a maximum of 30 characters. (You can define a storage array password by using the set storageArray command.)

The polling interval and the number of iterations that you specify remain in effect until you end the session. After you end the session, the polling interval and the number of iterations return to their default values.

Set Snapshot Group Attributes

Description

This command defines the properties for a snapshot group.

Syntax

set snapGroup ["snapGroupName"] (userLabel="snapGroupName" repositoryFullPolicy=(failBaseWrites purgeSnapImages) repositoryFullLimit=percentValue autoDeleteLimit=numberOfSnapImages rollbackPriority=(lowest low medium high highest))

Parameters

Parameter	Description
snapGroup	The alphanumeric identifier (including - and _) of
	the snapshot group for which you are setting
	properties. Enclose the snapshot group name in
	double quotation marks (" ") inside of square
	brackets ([ ]).
userLabel	The new alphanumeric identifier (including - and _)
	that you want to give to the snapshot group. Use
	this parameter when you want to rename the
	snapshot group. Enclose the new snapshot group
	name in double quotation marks (" ").

310