Loading media
6 Loading media
For adjustments and simple installation work, use the accompanying hexagonal wrench located in the bottom section of the print unit. See Fig. 5, Item 8. No other tools are required for the work described here.
6.1Loading labels from a roll
6.1.1Removing and installing the core adapter
A core adapter is mounted for better guidance of the label roll on the roll retainer when using label rolls with a core diameter ≥ 75 mm. Remove core adapter for smaller label rolls as follows.
1
2
3
4
Removing the core adapter
1.Open cover (1).
2.Loosen retaining screws of core adapter (2) with hexagonal wrench.
3.Remove core adapter from roll retainer (4).
Installing the core adapter
1.Open cover (1).
2.Loosen retaining screws of core adapter (2) with hexagonal wrench.
3.Slide first core adapter onto the roll retainer
(4)until it stops at the housing and tighten retaining screw.
4.Slide second core adapter onto the roll retainer (4) based on the roll width and tighten retaining screw.
Fig. 4: Installing the core adapter
10 | Quick Operator’s Guide | Edition 7/06 |
