Cleaning and basic maintenance
8.4Cleaning the label sensor
When: when the label roll is changed
CAUTION!
Label sensor can be damaged!
⇒Do not use sharp or hard objects or solvents to clean the label sensor.
The label sensor can become dirtied with paper dust. This can adversely affect label detection.
1
2
3
5
4
1.Turn lever (1) counterclockwise to lift the printhead.
2.Remove labels and transfer ribbon from the printer.
3.Remove hexagonal wrench (5) from its retainer.
4.Press the latch (3) and slowly pull label sen- sor outward via the tab (4). Ensure that the label sensor cable is not tensioned by this.
5.Clean label sensor and sensor units (2) with brush or cotton swab soaked in pure alcohol.
6.Push label sensor back via tab (3) and set it (see ”6.1.4” on page 12).
7.Push hexagonal wrench (5) into retainer.
8.Reload labels and transfer ribbon (see ”6.1” on page 10).
Fig. 14: Cleaning the label sensor
Edition 7/06 | Quick Operator’s Guide | 21 |
