Dell 32XX, 34XX, 38XX, 36XX manual Set Virtual Disk Mapping, Parameters

Parameters

Parameter	Description
target	Specifies the name of the target virtual disk for
	which to define properties. You must put brackets
	([ ]) around the target virtual disk name. If the target
	virtual disk name has special characters, you must
	also put quotation marks (" ") around the target
	virtual disk name.
source	Specifies the name of the source virtual disk for
	which to define properties. You must put brackets
	([ ]) around the source virtual disk name. If the
	source virtual disk name has special characters,
	you must also put quotation marks (" ") around the
	source virtual disk name.
copyPriority	Specifies the priority that the virtual disk copy has
	relative to host I/O activity. Valid entries are
	highest, high, medium, low, or lowest.
targetReadOnlyEnabled	Specifies whether the target virtual disk is write
	enabled or read only. To be able to write to the
	target virtual disk, set to FALSE. To prevent writing
	to the target virtual disk, set to TRUE.
copyType	Use this parameter to identify that a virtual disk
	copy has a snapshot (legacy). If the virtual disk
	copy has a snapshot (legacy), set this parameter to
	online. If the virtual disk copy does not have a
	snapshot (legacy), set this parameter to offline.

NOTE: When using this command, you can specify one or more of the parameters. You do not, however, need to use all of the parameters.

Set Virtual Disk Mapping

Description

This command defines the logical unit number (LUN) mapping between a virtual disk a host or host group. This command is applicable to virtual disks in either a disk group or disk pools.

NOTE: You cannot use this command for a snapshot virtual disk that is used in online virtual disk copy

Syntax

To map a PiT snapshot to the host, use the following syntax:

create mapping virtualDisk="snapshotVirtualdiskName" logicalUnitNumber=LUN host="hostName"

338