Dell 38XX, 34XX, 32XX, 36XX manual Enable Storage Array Feature, Establish Remote Replicated Pair

Parameter	Description
	from the rear of the enclosure. You must put
	brackets ([ ]) around the RAID controller module
	identifier. If you do not specify a RAID controller
	module, the storage management software returns
	a syntax error.

Enable Storage Array Feature

Description

This command enables a premium feature using a feature key file.

Syntax

enable storageArray (featurePack feature) file=”filename”

Parameter

Parameter	Description
file	File path and file name of a valid feature key file.
	Valid file names for feature key files must end with
	a .key extension. You must put quotation marks ("
	") around the file path and file name.

Additional Information

A feature pack is a predefined set of premium features, such as Storage Partitioning and Remote Replication. These premium features are combined for the convenience of the users.

A premium feature is an additional application to enhance the capabilities of a storage array.

NOTE: Before you enable the High Performance Tier premium feature, stop all host I/O operations to the storage array. When you enable the High Performance Tier premium feature, both RAID controller modules in the storage array immediately reboot.

Establish Remote Replicated Pair

Description

Use this command to complete a remote replicated pair on the remote storage array by adding a secondary virtual disk to an existing remote replication group. Before you run this command, the remote replication group must exist and the primary virtual disk must exist in the remote replication group. After this command successfully completes, remote replication starts between the primary virtual disk and the secondary virtual disk.

229