Dell 38XX, 34XX, 32XX, 36XX manual SecurityType=none capable enabled dataAssurance=none enabled

[securityType=(none capable enabled)] [dataAssurance=(none enabled)]

Parameters

Parameter	Description
physicalDisks	Specifies the physical disks to assign to the created
	virtual disk. Specify the enclosure ID and slot ID for
	each unassigned physical disk to assign to the
	virtual disk. Enclosure ID values are 0 to 99. Drawer
	ID values are 0 to 4. Slot ID values are 0 to 31. You
	must put parentheses around the enclosure ID
	values and the slot ID values.
diskGroupUserLabel	The alphanumeric identifier (including – and _)
	that you want to give the new disk group. Enclose
	the disk group identifier in square brackets ([]).
raidLevel	RAID level of the disk group that contains the
	virtual disk. Valid values are 0, 1, 5, or 6.
	NOTE: If you set the raidLevel parameter to
	RAID 1, the RAID controller module firmware
	takes the list of physical disks and pairs them
	using the following algorithm:
	Data physical disk = X
	Consistency physical disk = N / 2 + X
	where, X goes from 1 to N / 2 and N is the
	number of physical disks in the list. The
	following data show an example of six
	physical disks and their replication pairs.
	Data	Consistency
	1	N / 2 + 1 = 4
	2	N / 2 + 1 = 5
	3	N / 2 + 1 = 6
userLabel	Name that you want to give the new virtual disk.
	You must put quotation marks (" ") around the new
	virtual disk name.

NOTE: You can use any combination of alphanumeric characters, hyphens, and underscores for the names. Spaces are not allowed. Names can have a maximum of 30 characters.

177