Dell 34XX, 38XX, 32XX, 36XX manual NewCapacity, RepositoryMaxCapacity, AddRepositoryCapacity

Parameters

Parameter	Description
virtualDisk or virtualDisks	The name of the specific virtual disk for which you
	want to define properties. (You can enter more
	than one virtual disk name if you use the
	virtualDisks parameter.) Enclose the virtual disk
	name in double quotation marks (" ") inside of
	square brackets ([ ]).
virtualDisk	The World Wide Identifier (WWID) of the virtual disk
	for which you are setting properties. You can use
	the WWID instead of the virtual disk name to
	identify the virtual disk. Enclose the WWID in angle
	brackets (< >).
newCapacity	Increase the virtual capacity of the thin virtual disk.
	This is the value that the virtual disk will report to a
	host that is mapped to the virtual disk. Values
	smaller or equal to the existing capacity will cause
	an error.
	NOTE: The maximum capacity is 250 GB.
repositoryMaxCapacity	Set the maximum capacity of the repository virtual
	disk. The value must not be smaller that the
	physical capacity of the repository virtual disk. If
	the new value results in a reduction in capacity to a
	level below the warning threshold, the command
	will produce an error.
repositoryExpansionPolicy	Set the expansion policy to automatic or manual.
	When you change the policy from automatic to
	manual, the maximum capacity value (quota)
	changes to the physical capacity of the repository
	virtual disk.
warningThresholdPercent	Adjust the warning threshold. If a change to this
	value would cause a warning condition, the
	command will fail and produce an error.
addRepositoryCapacity	Allocate capacity from the free extent of the disk
	pool. If insufficient space is available the command
	fails.

Notes

When you use this command, you can specify one or more of the optional parameters.

328