Dell 32XX, 34XX, 38XX, 36XX manual Source, CopyPriority, TargetReadOnlyEnabled, CopyType

Parameters

Parameter	Description
source	Name of an existing virtual disk to use as the
	source virtual disk. You must put quotation marks ("
	") around the source virtual disk name.
	NOTE: You can use any combination of
	alphanumeric characters, hyphens, and
	underscores for the names. Command names
	can have a maximum of 30 characters. If you
	exceed the maximum character limit, replace
	square brackets ([ ]) with angle brackets (< >)
	to overcome this limitation.
target	Name of an existing virtual disk to use as the target
	virtual disk. You must put quotation marks (" ")
	around the target virtual disk name.
	NOTE: You can use any combination of
	alphanumeric characters, hyphens, and
	underscores for the names. Command names
	can have a maximum of 30 characters. If you
	exceed the maximum character limit, replace
	square brackets ([ ]) with angle brackets (< >)
	to overcome this limitation.
copyPriority	Specifies the priority that a virtual disk copy has
	relative to host I/O activity. Valid entries are
	highest, high, medium, low, or lowest.
	NOTE: CopyPriority defines the amount of
	system resources used to copy the data
	between the source virtual disk and target
	virtual disk of a virtual disk-copy pair. If you
	select the highest priority level, the virtual disk
	copy uses the most system resources to
	perform virtual disk copy, which decreases
	performance for host data transfers.
targetReadOnlyEnabled	Specifies whether the target virtual disk is write
	enabled or read only. To be able to write to the
	target virtual disk, set this parameter to FALSE. To
	prevent writing to the target virtual disk, set this
	parameter to TRUE.
copyType	Creates a virtual disk copy with or a snapshot
	(legacy). Creating a virtual disk copy with a
	snapshot (legacy) enables you to continue to write
	to the source virtual disk while creating the virtual
	disk copy. To create a virtual disk copy with a

202