Dell 38XX, 34XX, 32XX Diagnose RAID Controller Module iSCSI Host Cable, PatternFile, IscsiHostPort

Parameter	Description
	NOTE: When you run a data loop-back test,
	you can optionally specify a file that contains
	a data pattern. If you do not specify a file, the
	RAID controller module firmware provides a
	default pattern.
patternFile	File path and file name of the file that contains a
	data pattern to use as test data. Enclose the path
	and file name with quotation marks (" ").

Diagnose RAID Controller Module iSCSI Host Cable

Description

NOTE: This command valid only for the PowerVault MD3800i storage array.

This command runs diagnostic tests on the copper cables between the iSCSI Host interface cards and a RAID controller module. You can run diagnostics on a selected port or all ports. The ports must be able to support the cable diagnostics. If the ports do not support cable diagnostics an error is returned

Syntax

diagnose controller [(0 1)] iscsiHostPort[(all (0 1))] testID=cableDiagnostics

Parameters

Parameter	Description
controller	Controller specifies the RAID controller module on
	which you want to run the cable diagnostic test.
	Valid RAID controller module identifier values are 0
	and 1. The identifier value is 0 for the RAID
	controller module on the top and 1 for the RAID
	controller module on the bottom when viewed
	from the rear of the enclosure. Enclose the RAID
	controller module identifier in square brackets ([ ]).
	If a RAID controller module is not specified, the MD
	storage management software returns a syntax
	error.
iscsiHostPort	Specifies the iSCSI host port on which you want to
	run the diagnostic tests. You can either run the
	diagnostics on all iSCSI host ports or run it on a
	specific iSCSI host. Valid values for the specific
	iSCSI host port identifiers are 0 or 1. Enclose the
	iSCSI host port identifier in square brackets ([ ]).

217