Dell 36XX, 34XX, 38XX, 32XX manual ReadCacheEnabled, WriteCacheEnabled

Parameter	Description
	this parameter only if you want to change the
	virtual disk owner.
readCacheEnabled	The setting to turn on or turn off the read cache.
	To turn on the read cache, set this parameter to
	TRUE. To turn off the read cache, set this
	parameter to FALSE.
writeCacheEnabled	The setting to turn on or turn off the write cache.
	To turn on the write cache, set this parameter to
	TRUE. To turn off the write cache, set this
	parameter to FALSE.
cacheReadPrefetch	The setting to turn on or turn off cache read
	prefetch. To turn off cache read prefetch, set this
	parameter to FALSE. To turn on cache read
	prefetch, set this parameter to TRUE.
addCapacity	The setting to increase the storage size (capacity)
	of the virtual disk for which you are defining
	properties. Size is defined in units of bytes, KB, MB,
	GB, or TB. The default value is bytes.
	NOTE: A space must be added between the
	last digit and the size (bytes, KB, MB, or GB) for
	values greater than 9.
addPhysicalDisks	Adds new physical disks to the virtual disk. Specify
	the enclosure ID and slot ID for each physical disk
	that you assign to the virtual disk. Enclosure ID
	values are 0 to 99. Slot ID values are 0 to 31. You
	must put brackets ([ ]) around the enclosure ID
	values and the slot ID values. Use with the
	addCapacity parameter if you must specify
	additional physical disks to accommodate the new
	size.
consistencyCheckEnabled	Turns consistency checking during a media scan
	on or off. To turn consistency checking on, set to
	TRUE. To turn consistency checking off, set to
	FALSE.
segmentSize	Amount of data (in kilobytes) that the RAID
	controller module writes on a single physical disk
	in a virtual disk before writing data on the next
	physical disk. Valid values are 8, 16, 32, 64, 128,
	256, or 512. For information about the
	segmentSize parameter, see Using The Auto
	Configure Command.

331