Dell 36XX, 34XX, 38XX, 32XX manual New name that you want to give to the remote

Parameter	Description
	specify the length of time in minutes, hours, or
	days.
	NOTE: You must set the Recovery Point
	Threshold to be twice as large as the
	synchronization interval threshold.
warningThresholdPercent	Specify the percent value that determines when a
	warning is triggered when the capacity of a
	replication repository virtual disk reaches the
	defined percentage. Define the threshold by
	percentage (%) of the capacity remaining.
userLabel	The new name that you want to give to the remote
	replication group. Use this parameter when you
	want to rename the remote replication group.
	Enclose the new remote replication group name in
	double quotation marks (" ").
autoResync	The settings for automatic resynchronization
	between the primary virtual disks and the
	secondary virtual disks of a remote replicated pair
	within a remote replication group. This parameter
	has these values:
	• enabled—Automatic resynchronization is
	turned on. You do not need to do anything
	further to resynchronize the primary virtual disk
	and the secondary virtual disk.
	• disabled—Automatic resynchronization is
	turned off. To resynchronize the primary virtual
	disk and the secondary virtual disk, you must
	run the resume remoteReplicationGroup
	command.
virtualDisk	The name of the specific virtual disk that you want
	to modify in the remote replication group. Enclose
	the virtual disk name in double quotation marks ("
	").
repositoryVirtualDisk	The name of the repository virtual disk for which
	you want to increase capacity. An available
	standard virtual disk is added to the repository
	virtual disk to increase the capacity of the
	repository virtual disk.
	You have two options for defining the name of a
	repository virtual disk:
	• Use an existing repository virtual disk name.
	• Create a new repository virtual disk when you
	run this command.
	The name of an existing repository virtual disk is
	comprised of two parts:
	• The term repos

307