Dell 32XX, 34XX, 38XX, 36XX manual Reinitialize Thin Virtual Disk, ExistingRepositoryLabel

Syntax

create snmpTrapDestination trapReceiverIP=ipAddress communityName="communityName" [sendAuthenticationFailureTraps=(TRUE FALSE)]

Parameters

Parameter	Description
trapReceiverIP	The IP address of the SNMP manager to which you
	want to send trap messages.
communityName	The name of the SNMP community for which you
	want to send trap messages.
sendAuthenticationFailureTraps	This parameter turns on or turns off sending
	authentication failure messages to an SNMP
	manager. To send authentication failure messages,
	set the parameter to TRUE. To prevent sending
	authentication failure messages, set the parameter
	to FALSE. The default is FALSE.

Reinitialize Thin Virtual Disk

Description

This command re-initializes a thin virtual disk.

NOTE: Formatting a virtual disk starts a long-running operation that cannot be stopped.

Syntax

start virtualDisk [virtualDiskName] initialize [existingRepositoryLabel=existingRepositoryName]

[diskPool=diskPoolName capacity=capacityValue] [retainRepositoryMembers=(TRUE FALSE)]

Parameters

Parameter	Description
virtualDisk	The name of the virtual disk for which you are
	starting the formatting. Enclose the virtual disk
	name in square brackets ([ ]). If the virtual disk
	name has special characters, you also must
	enclose the virtual disk name in double quotation
	marks (" ").
existingRepositoryLabel	Causes the repository virtual disk to be replaced by
	the candidate virtual disk specified.
	• The value specified is an existing repository
	virtual disk user label. The virtual disk specified

246