Dell 34XX, 38XX Availability, ServiceMode service, EthernetPort, GlobalNVSRAMByte, HostNVSRAMByte

Parameters

Parameter	Description
controller	The RAID controller module for which you want to
	define properties. Valid RAID controller module
	identifiers are 0 or 1, where 0 is the RAID controller
	module in the top slot, and 1 is the RAID controller
	module in the bottom slot. Enclose the identifier
	for the RAID controller module in square brackets
	([ ]). If you do not specify a RAID controller module,
	the firmware for the controller returns a syntax
	error.
availability	The mode for the RAID controller module, which
	you can set to online, offline, or
	serviceMode (service).
ethernetPort	The attributes (options) for the management
	Ethernet ports. The entries to support this
	parameter are listed in the Syntax Element
	Statement Data table that follows. Many settings
	are possible, including setting the IP address, the
	gateway address, and the subnet mask address.
globalNVSRAMByte	A portion of the RAID controller module NVSRAM.
	Specify the region to be modified using the starting
	byte offset within the region and the byte value or
	bit value of the new data to be stored into the
	NVSRAM.
hostNVSRAMByte	The NVSRAM for the host-specific region. The
	setting specifies the host index for the specific
	host, the starting offset within the region, the
	number of bytes, and the byte value or bit value of
	the new data to be stored into the NVSRAM.
IPv4GatewayIP	The IP address of the node that provides the
	interface to the network. The address format for
	the IPv4 gateway is (0–255).(0–255).(0–255).
	(0–255)
IPv6RouterAddress	The IP address of IPv6 router that connects two or
	more logical subnets. The address format for the
	IPv6 router is (0–FFFF):(0–FFFF):(0–FFFF):
	(0–FFFF): (0–FFFF):(0–FFFF):(0–FFFF):
	(0–FFFF).
iscsiHostPort	This parameter enables you to set options for the
	iSCSI ports on the RAID controller module. Select
	the specific iSCSI port and then select the options
	for that port. The iSCSI port identifier can be 0, 1 or
	2, 3. Refer to the information about your RAID
	controller module for the location and identifier of
	the ports.

300