Dell 36XX, 34XX Capacity=500 bytes, Capacity=2 GB, Owner, FileSystem, dataBase, or multiMedia

Parameter	Description
	• allMedia — Use this option when you want to use all types of
	physical disk media that are in the expansion enclosure.
physicalDiskType	The type of physical disk that you want to use in the virtual disk.
	You cannot mix physical disk types. The valid physical disk type is
	SAS. You must specify a physical disk type.
capacity	The size of the virtual disk that you are adding to the storage
	array. Size is defined in units of bytes, KB, MB, GB, or TB. The
	following examples show the syntax:
	capacity=500 bytes
	capacity=2 GB
	NOTE: A space must be added between the last digit and the
	size (bytes, KB, MB, or GB) for values greater than 9. If you
	do not specify a capacity, all the available physical disk
	capacity in the disk group is used. If you do not specify the
	capacity unit, bytes is used as the default unit.
owner	The setting for which RAID controller module owns the disk
	group. Valid RAID controller module identifier values are 0 and 1.
	The identifier value is 0 for the RAID controller module on the top
	and 1 for the RAID controller module on the bottom when
	viewed from the rear of the enclosure. If you do not specify an
	owner, the RAID controller module firmware determines the
	owner.
cacheReadPrefetch	The setting to turn on or turn off cache read prefetch. To turn off
	cache read prefetch, set this parameter to FALSE. To turn on
	cache read prefetch, set this parameter to TRUE.
segmentSize	The amount of data (in KB) that the RAID controller module
	writes on a single physical disk in a virtual disk before writing data
	on the next physical disk. Valid values are 8, 16, 32, 64, 128, 256,
	or 512.
usageHint	The setting for both the cacheReadPrefetch parameter and
	the segmentSize parameter to be default values. The default
	values are based on the typical I/O usage pattern of the
	application that is using the virtual disk. Valid values are
	fileSystem, dataBase, or multiMedia.
enclosureLossProtect	The setting to enforce enclosure loss protection when you create
	the disk group. To enforce enclosure loss protection, set this
	parameter to TRUE. The default value is FALSE.
drawerLossProtect	The setting to enforce drawer loss protection when you create
	the disk group. To enforce drawer loss protection, set this
	parameter to TRUE. The default value is FALSE.
securityType	The setting to specify the security level when creating the disk
	groups and all associated virtual disks.
	• none—The disk group and virtual disks are not secure.

163