Parameter

Description

 

 

readOnly

This parameter sets the snapshot virtual disk to

 

read-only. This parameter is actually a Boolean;

 

however, in the context of this command, the

 

Boolean value is always TRUE.

 

NOTE: With the readOnly parameter,

 

snapshot virtual disks are not created.

Notes

You can use any combination of alphanumeric characters, underscore (_), hyphen (-), and pound (#) for the names. Names can have a maximum of 30 characters.

The identifier of a snapshot image has two parts separated by a colon (:):

The name of the snapshot group.

The identifier of the snapshot image.

For example, if you want to create a read-only virtual disk named engData1 using the most recent snapshot image in a snapshot group that has the name snapGroup1, you would use this command:

create snapVirtualDisk userLabel="engData1" snapImageID="snapGroup1:newest" readOnly;

Create Remote Replication

NOTE: This command is valid only with Fibre Channel storage arrays.

Description

This command creates both the primary virtual disk and the secondary virtual disk for a remote replication pair. This command also sets the write mode (Synchronous or Asynchronous) and the synchronization priority.

Syntax

create remoteReplication primary= ”primaryVirtualDiskName” secondary=”secondaryVirtualDiskName” (remoteStorageArrayName=”storageArrayName” remoteStorageArrayWwn=”wwID”) [remotePassword=”password” syncPriority=(highest high medium low lowest)

autoResync=(enabled disabled) writeOrder=(preserved notPreserved) writeMode=(synchronous asynchronous)]

182

Page 182
Image 182
Dell 32XX, 34XX, 38XX, 36XX manual Create Remote Replication, ReadOnly