Dell 36XX, 34XX, 38XX, 32XX manual For mapping Legacy snapshot and any virtual disk

For mapping Legacy snapshot and any virtual disk:

set (virtualDisk ["virtualDiskName"] virtualDisk <wwID> accessVirtualDisk) logicalUnitNumber=LUN

(host="hostName" hostGroup=("hostGroupName" defaultGroup)

Parameters

Parameter	Description
virtualDisk	The name of the specific virtual disk for which you
	want to define mapping. Enclose the virtual disk
	name in double quotation marks (" ") inside of
	square brackets ([ ]).
	The World Wide Identifier (WWID) of the virtual disk
	for which you are setting properties. You can use
	the WWID instead of the virtual disk name to
	identify the virtual disk. Enclose the WWID in angle
	brackets (< >).
accessVirtualDisk	The logical unit number for the virtual disk. The
	logical unit number is the only property that you
	can set for the virtual disk.
logicalUnitNumber	The logical unit number that you want to use to
	map to a specific host. This parameter also assigns
	the host to a host group.
host	The name of the host to which the virtual disk is
	mapped. Enclose the host name in double
	quotation marks (" ").
hostGroup	The name of the host group to which the virtual
	disk is mapped. Enclose the host group name in
	double quotation marks (" "). defaultGroup is the
	host group that contains the host to which the
	virtual disk is mapped.

Notes

A host group is an optional topological element that you can define if you want to designate a collection of hosts that share access to the same virtual disks. The host group is a logical entity. Define a host group only if you have two or more hosts that can share access to the same virtual disks.

You can use any combination of alphanumeric characters, hyphens, and underscores for the names. Names can have a maximum of 30 characters.

The access virtual disk is the virtual disk in a SAN environment that is used for in-band communication between the storage management software and the storage array RAID controller module. This virtual disk uses a LUN address and consumes 20 MB of storage space that is not available for application data storage. An access virtual disk is required only for in-band managed storage arrays. If you specify the accessVirtualDisk parameter, the only property you can set is the logicalUnitNumber parameter.

339