Parameter

Description

 

 

enclosureLossProtect

The setting to enforce enclosure loss protection

 

when you create the replication repository virtual

 

disk. To enforce enclosure loss protection, set this

 

parameter to TRUE. The default value is FALSE.

drawerLossProtect

The setting to enforce drawer loss protection

 

when you create the replication repository virtual

 

disk. To enforce drawer loss protection, set this

 

parameter to TRUE. The default value is FALSE.

dataAssurance

The setting to specify that a disk group, and the

 

virtual disks within the disk group, has data

 

assurance protection to make sure that the data

 

maintains its integrity. When you use this

 

parameter, only protected physical disks can be

 

used for the disk group. These settings are valid:

 

• none - The disk group does not have data

 

assurance protection.

 

• enabled - The disk group has data assurance

 

protection. The disk group supports protected

 

information and is formatted with protection

 

information enabled.

Notes

The repositoryPhysicalDisks parameter supports both high-capacity expansion enclosures and low-capacity expansion enclosures. A high-capacity expansion enclosure has drawers that hold the physical disks. The drawers slide out of the expansion enclosure to provide access to the physical disks. A low-capacity expansion enclosure does not have drawers. For a high-capacity expansion enclosure, you must specify the identifier (ID) of the expansion enclosure, the ID of the drawer, and the ID of the slot in which a physical disk resides. For a low-capacity expansion enclosure, you need only specify the ID of the expansion enclosure and the ID of the slot in which a physical disk resides. For a low-capacity expansion enclosure, an alternative method for identifying a location for a physical disk is to specify the ID of the expansion enclosure, set the ID of the drawer to 0, and specify the ID of the slot in which a physical disk resides.

If the physical disks that you select for the repositoryPhysicalDisks parameter are not compatible with other parameters (such as the repositoryRAIDLevel parameter), the script command returns an error, and Remote Replication (Legacy) is not activated. The error returns the amount of space that is needed for the replication repository virtual disk. You can then re-enter the command, and specify the appropriate amount of space.

If you enter a value for the repository storage space that is too small for the replication repository virtual disks, the RAID controller module firmware returns an error message that provides the amount of space that is needed for the replication repository virtual disks. The command does not try to activate Remote Replication (Legacy). You can re-enter the command by using the value from the error message for the repository storage space value.

When you assign the physical disks, if you set the enclosureLossProtect parameter to TRUE and have selected more than one physical disk from any one enclosure, the storage array returns an error. If you

135

Page 135
Image 135
Dell 36XX, 34XX, 38XX, 32XX manual EnclosureLossProtect, DrawerLossProtect, DataAssurance