Dell 36XX, 34XX, 38XX, 32XX manual DiskPoolUserLabel, RetainRepositoryMember

Parameter	Description
	must be an unused repository virtual disk with
	the name in the proper form.
	• If the newly specified repository virtual disk is
	on a different disk pool, the thin virtual disk will
	change ownership to that pool.
	• The old repository virtual disk will be deleted by
	default.
diskPoolUserLabel	Use this parameter to allocate a new repository
	virtual disk with the specified capacity.
retainRepositoryMember	If this parameter is set to TRUE, the old repository
	is retained. By default, the old repository is deleted.
	This parameter is ignored if the existing repository
	is reused.

Remove Incomplete Remote Replicated Pair From Remote Replication Group

Description

This command removes an orphaned replicated pair virtual disk on the storage array. An orphaned replicated pair virtual disk exists when a member virtual disk in a remote replication group has been removed on one side of the remote replication group (either the primary side or secondary side) but not on the other side.

Orphan replicated pair virtual disks are detected when inter-RAID controller module communication is restored and the two sides of the replication configuration reconcile replication parameters.

Use this command when the replicate relationship is successfully removed on the local or remote storage array, but cannot be removed on the corresponding storage array because of a communication problem.

Syntax

remove asyncRemoteReplicationGroup ["asyncRemoteReplicationGroupName"] incompleteReplication virtualDisk="virtualDiskName"

Parameters

Parameter	Description
asyncRemoteReplicationGroup	The name of the remote replication group that
	contains the orphaned virtual disk that you want to
	remove. Enclose the remote replication group
	name in double quotation marks (" "). If the remote
	replication group name has special characters, you
	also must enclose the remote replication group

247