Dell 32XX, 34XX, 38XX, 36XX manual Name of the target virtual disk for which to

CAUTION: Before you create a new copy of a source virtual disk, stop any data access (I/O) activity or suspend data transfer to the source virtual disk and (if applicable, the target disk) to ensure that you capture an accurate point-in-time image of the source virtual disk. Close all applications, including Windows Internet Explorer, to make sure all I/O activity has stopped.

NOTE: Removing the drive letter of the associated virtual disk(s) in Windows or unmounting the virtual drive in Linux helps to guarantee a stable copy of the drive for the virtual copy.

Syntax

recopy virtualDiskCopy target [targetName] [source [sourceName]]

[copyPriority=(highest high medium low lowest) targetReadOnlyEnabled=(TRUE FALSE)] copyType=(online offline)

Parameters

Parameter	Description
target	Name of the target virtual disk for which to
	reinitiate a virtual disk copy operation. You must
	put brackets ([ ]) around the target virtual disk
	name. If the target virtual disk name has special
	characters, you must also put quotation marks (" ")
	around the target virtual disk name.
source	Name of the source virtual disk for which to
	reinitiate a virtual disk copy operation. You must
	put brackets ([ ]) around the source virtual disk
	name. If the source virtual disk name has special
	characters, you must also put quotation marks (" ")
	around the source virtual disk name.
copyPriority	Specifies the priority that the virtual disk copy has
	relative to host I/O activity. Valid entries are
	highest, high, medium, low, or lowest.
	NOTE: CopyPriority defines the amount of
	system resources used to copy the data
	between the source and target virtual disks of
	a virtual disk copy pair. If you select the
	highest priority level, the virtual disk copy uses
	the most system resources to perform virtual
	disk copy, which decreases performance for
	host data transfers.
targetReadOnlyEnabled	Specifies whether the target virtual disk is write
	enabled or read only. To be able to write to the
	target virtual disk, set this parameter to FALSE. To
	prevent writing to the target virtual disk, set this
	parameter to TRUE.

234