Dell 34XX, 38XX, 32XX, 36XX manual Autoconfigure-vols-attr-value-pair

Recurring Syntax	Syntax Value
	[physicalDiskType=physical disk-type]
	[enclosureLossProtect=boolean]
WWID	string-literal
	For hostPort identifiers this is a 16-digit hex
	number without any colon delimiters.
nvsram-offset	hexadecimal-literal
host-type	string-literal integer-literal
nvsram-byte-setting	nvsram-value
	(0x hexadecimal integer-literal)
nvsram-bit-setting	nvsram-mask, nvsram-value
	(0x hexadecimal, 0x hexadecimal integer-literal)
ipv4-address	(0–255).(0–255).(0–255).(0–255)
ipv6-address	(0-FFFF):(0-FFFF):(0-FFFF):
	(0-FFFF):(0-FFFF):(0-FFFF):
	(0-FFFF):(0-FFF)
autoconfigure-vols-attr-value-list	autoconfigure-vols-attr-value-pair
	{autoconfigure-vols-attr-value-pair}
autoconfigure-vols-attr-value-pair	physicalDiskType=physical disk-type
	raidLevel=raid-level
	diskGroupWidth=integer-literal
	diskGroupCount=integer-literal
	virtualDisksPerGroupCount=integerliteral
	hotSpareCount=integer-literal
	segmentSize=segment-size-spec
	NOTE: The physicalDiskType parameter is
	not required if only one type of physical disk is
	in the storage array. If you use the
	physicalDiskType parameter, you must
	also use the hotSpareCount and
	diskGroupWidth parameters. If you do not
	use the physicalDiskType parameter, the
	configuration defaults to SAS physical disks.

36