Using the Web Console
3. Click New and configure these fields.
Field | Description | |
|
| |
Interface Name | Specifies the name of the IP interface. The default VLAN interface name is | |
System. | ||
| ||
|
| |
IP Address | Specifies the IP address of the IP interface (sometimes referred to as a | |
network address). | ||
| ||
|
| |
Subnet Mask | Specifies the subnet mask for the IP address. | |
|
| |
VLAN Name | Specifies the VLAN that is assigned to this IP interface. This VLAN must | |
already exist. The IP interface gets its port membership from the VLAN. | ||
| ||
|
| |
Active | Enables or disables the IP interface. | |
|
| |
Port Member | Specifies the ports which are to be members of this IP interface. | |
|
|
4.Click Apply.
5.To delete an IP interface, highlight the interface and click Delete.
If you modify an existing IP interface and apply the changes, the RIP and IP multicast interface configurations are reset to default values.
RIP Configuration
The Routing Information Protocol (RIP) is a
To globally enable or disable RIP
1.In the left panel, click Layer 3 IP Networking.
2.In the top panel under IP Interface Settings, click RIP Status.
3.In the RIP field, select either Disabled or Enabled.
4.Click Apply.
To configure RIP interface settings
An IP Interface must be defined before you can configure its RIP settings.
1.In the left panel, click Layer 3 IP Networking.
2.In the top panel under IP Interface Settings, click RIP Interface Settings.
3.Select the interface you want to configure and click Edit.
ZT8101 Users Guide | 115 |