Using the Web Console
The following ARP information is displayed.
Field | Description | |
|
| |
Interface Name | The IP interface name corresponding to the IP address. | |
|
| |
IP Address | The IP address that corresponds to the MAC address. | |
|
| |
MAC Address | The MAC address that corresponds to the IP address. | |
|
| |
Type | The method that was used to enter the MAC address and IP address pair | |
into the ARP table. The possible entries are Static, Dynamic, and Local. | ||
| ||
|
|
Status
To view GVRP Status
1.In the left panel, click Network Monitoring.
2.In the top panel under Status, click GVRP Status.
The screen contains this information.
Field | Description | |
|
| |
IEEE 802.1Q VLAN ID | The ID assigned to the currently displayed VLAN. | |
|
| |
| The status of the VLAN, whether it is a permanent | |
Status | definition or whether the ports dynamically joined the | |
| VLAN. | |
|
| |
Creation time since switch power up | The time the VLAN was created or last modified, | |
relative to when the switch was last booted. | ||
| ||
|
| |
Current Egress Ports | The ports in the VLAN which are egress ports. | |
|
| |
Current Untagged Ports | The ports in the VLAN which are untagged. | |
|
| |
Number of IEEE 802.1Q VLANs | The number of VLANs that have been defined for the | |
switch. | ||
| ||
|
|
If more than one IEEE 802.1Q VLAN has been defined for the switch, click Next to view the status of the other VLANs.
To view router ports
Router ports can be either static or dynamic. Static ports are ports that you manually configure to route UDP multicast packets. Dynamic ports are added by the switch when the switch detects UDP multicast packets and IGMP multicast group membership reports on a port.
1.In the left panel, click Network Monitoring.
2.In the top panel under Status, click Router Ports.
3.In the VLAN field, enter the name of the VLAN to search for router ports.
4.Click Find.
The Router Port table contains the VLAN name, and under the port groupings (1 to 8, 9 to 16, 17 to 24, and 25 to 26), a port is assigned an “S” if the port is a static router port, a “D” if the port has been dynamically assigned to be a router port, or a
ZT8101 Users Guide | 101 |