Using the Web Console
IP Address Filtering
You can manually configure the switch to drop packets from specified MAC and IP addresses. For information about specifying MAC addresses to drop, see the Forwarding Unicast MAC Address Setting screen
To specify an IP address for filtering
1.In the left panel, click IP Address Filtering.
2.Click New and configure these fields:
Field | Description |
|
|
IP Address | Specifies the IP address of the packets you want dropped. |
Specifies the condition for filtering the packets:
•Destination— Packets with the above IP address as their destination will be dropped.
Source/Destination
•Source— Packets with the above IP address as their source will be dropped.
•Either— All packets with the above IP address will be dropped.
3.Click Apply.
The entry is added to the table.
4.To remove an entry, select the entry in the table and click Remove.
MAC Address Priority
You can specify a MAC address so that packets with this address are given special handling, either a higher or lower priority than normal traffic.
Note: If flow control is enabled, a small of amount of low priority traffic may be forwarded before high priority traffic.
To set up a MAC address priority
1.In the left panel, click MAC Address Priority.
2.Click New and configure these fields.
Field | Description |
|
|
MAC Address | Specifies the MAC address to set a priority for. |
|
|
110 | ZT8101 Users Guide |
