Using the Web Console
You can configure up to six aggregation groups, each using from two to eight ports between any two ZT8101 switches or other switches that support Etherchannel. Etherchannel is only required for this first release. In the second release, the ports can be from any switch that is compliant with 802.1ad.
To configure a link aggregation group
1.In the left panel, click Link Aggregation.
2.Select a group to configure and click Edit.
3.Configure these fields for the group.
Field | Description | |
|
| |
| Specifies the first port in the group. This port’s configuration (speed, full- or | |
Starting Port | ||
| becomes the master port. | |
|
| |
Group Width | Specifies the number of ports, in sequential order from the master port, that | |
will be included in the group. | ||
| ||
|
| |
Status | Enables or disables the group. | |
|
|
4. Click Apply.
In addition to the configuration information, the table displays which port has been assigned to be the anchor port. The anchor port is responsible for the flooding of multicast frames and for sending control packets.
Layer 3 - IP Networking
This section describes how to configure
•IP interfaces
•RIP
•Multicast routing protocols
Setting Up IP Interfaces
Each IP interface on the switch corresponds to a VLAN. A VLAN, which does not have a corresponding IP interface defined for it, will function as a Layer
The switch allows ranges of IP addresses (OSI Layer 3) to be assigned to VLANs (OSI Layer 2). Each VLAN must be configured prior to setting up the corresponding IP interface.
To set up IP interfaces on the switch
1.In the left panel, click Layer 3 IP Networking.
2.In the top panel under IP Interface Settings, click IP Interface Settings.
114 | ZT8101 Users Guide |
