3-10 Smart Switch 1800 4. 0 User Guide , Rev 0 1
Where to Find Configuration Information
The following shows where to find the configuration f iles among the menus. (The first
item, A–Configuration, is an entry on the Main Menu.) Following some items are the
chapters/appendices in this manual where the items below those entries are described.
A Configuration
A Configure Node
AConfigure Password – (Cha pter 2 ) allows chang ing the defaul t login
passw ord.
BConfigure Time and Date – (Chapter 2) allows setting a correct time/
date that will be displayed on some screens and reports, and will allow
all Sma r t S wi t ch 1800s , F RX4/6000s, and 9W004s on a ne t work to b e in
sync, regarding reports and alarm messages that include the date and
time.
CConfigure Node D efaults – (Chapter 4) specifies IDs and passwords
used for remote control, file transfer, and alarm routing and reporting
operat ions.
D Configure SNMP P arameters – (Chapter 17) identifies the SNMP
manager; defines communities; and specifies SNMP trap routing.
AConfigure System Defaults
BConfigure Community Table
CConfigure Trap Routing
D Configure Model Number (not used, since SNMP recognizes only
one mod e l for th e Smart Switc h 18 00).
E Configure IP/LLC2/BRIDG E /IPX Default Parameter s
AConfigure IP Node Defaults – (Chapter 14) specifies whether the
SmartSwitch 1800 will act as an IP gateway a nd which ver sion of
RIP will be used.
B Configure Bridge / LLC-2 Node Defaults – ( Chapt e r 9,
Chapter 16) specifies parameters that will be used internally by the
node to identify a virtual bridge that will connect the LLC2 function
to LAN interfaces and frame relay PVCs.
CReview SNA LLC2 Host s – (Cha pt er 9) di s p lays a n y LLC2 ho sts
(see below) that have been configured on the SmartSwitch 1800.
DConfigure SNA LLC2 Hosts – (Chapter 9) defines LLC2 hosts on
the SmartSwitch 1800; includes session type (originated or
terminated), necessary addresses, timers.
EConfigure IPX Node Defaults – (C hapte r 15) defi n es op e ratio n o f
the SmartSwitch 1800 when used as an interface to a Novell
NetWare network.
F Configure Filter De fini tions and Applications
AReview IPX Filter Definitions – (Ch apter 15) displ ays a ny IPX
filters (see next item) that are configured on the SmartSwitch.
BConfigure IPX Filter Definitions – (Chapter 15) specifies
parame t ers fo r trans mi s s ion of RIP an d S A P updat e s, and /or
generic IPX packets, per interface and direction.
CReview IPX Filter Applications – (Chapter 15) displays
information on any IPX filter applications (see below)
configured on the SmartSwitch.
DConfigure IPX Filter Applications – (C hapt e r 15) ap pl ies IP X
filters to interfaces/filter types/directions.