Cabletron Systems 1800 Configuring DLCI Parameters (Figure 7-4, Item D)

7-12 Smart Switch 1800 4. 0 User Guide , Rev 0 1
Configuring DLCI Parameters (Figure 7-4, Item D)
To configure DLCI parameters ( listed in Table 7- 4), press [D] at Figure 7 -4 and, when
prompte d, en t e r a DLCI ID: 16–991. (T he defa ult is 16.) This will display a screen
similar to Figure 7-6.
Figure 7-6 Frame Relay DLCI Configuration Screen 1
Pressing [F4] at this or the subsequent screen (Figure 7-7) will de lete the
DLCI rate control and ba ckup configuration. (The p ort will not be de leted
unless [F4] is pressed at one of the higher-level port screens—Figure 7-3
and Figure 7-4.)
Note that the DLCI is not yet deleted. If it was created solely for frame
relay backup, it will remain in existence until th e node is rebooted. If the
DLCI was created when configur ing an IP, IPX, or L LC2 interface, it will
remain until that interface is deleted and the node is rebooted.
If a primary DLCI is brought down, then deleted from the
database while the backup is operational, end-to-end connec-
tivity over the backup will fail. For this reason, a primary DLCI
should n ever be dele ted. (If th ere is a need to d elete the DLC I, it
should first be re-configured so that it is not part of a frame relay
backup situation.)
Node Name=node_xyz
Frame Relay DLCI Configuration (s creen 1 of 2)
*RLP 0
*Port 7
*DLCI 16
A Committed Information Rate (In) 2000
B Committed Burst Size (In) 2000
C Excess Burst Size (In) 1000
D Committed Information Rate (Out) 2000
E Committed Burst Size (Out) 2000
F Excess Burst Size (Out) 1000
G BECN Recov ery C ount 8
H Outgoing DLCI Priority 0
I DL CI Backup Confi guration
Option: