10-10 Sm artSwit ch 1800 4.0 U ser Gui de, Rev 01
will redirects calls (if Y) according to the Redirection Addresses if the primary sub-
scribe r device is out of order .
Connection Priori ty
prioritizes intra-nodal traffic; the higher the number, the higher the priority. (This pri-
ority has no effect on traffic exiting a node.)
Priorities are configured on all logical interfaces that use a physical frame relay port.
The device processor in the node uses these priorities to help determine the order in
which it will process protocols.
When configuring priorities, be careful to consider the types of
traffic being routed on other connections in the node.
1st, 2nd,etc. Path Configured
includes or excludes the associated port as a routing path to the subscriber device. At
least one path must be specified.
Port identifies the port(s) that make up the routing path(s).
Redire cti o n Addres s 0, 1, etc.
are up to five subscribers that will be called according to the specified redirection
option.
Configuring BSC Interactive Devices
Port records contain the information that identifies ports configured for BSC Inter-
active operation. You must also define the devices connected to those ports.
To displ ay a lis t of confi g ured d evice s , press [A] at the BSC Devices Configuration
Menu (or [A], [C], [F], [A] from the Main Menu).
To configure a device, press [B] at the BSC Devices Configuration Menu. When
prompte d, e nter:
●RLP: Press [Enter], accepting the default of 0.
●BSC Port: 0–3. (Default is 0.)
●Cont ro l Unit:
0–31. (See Table 10-4.)
●Device Unit: 0–31. (See Table 10-4.) Up to 32 D evice U nits can be conf igure d
for each Control Unit.
●Any other requested information, noting the values in Table 10 -5 (on page 10-
12). (Pres s [Enter] at a prompt to specify the default value.)