Configuring Node Defaults 4-3
Node Defaults Parame ters

The parameters on the first two Node Defaults screens are listed in Table 4-1, and the

NetView parameters on th e third screen are listed in Table 4-2 (on page 4-6). Descrip-

tions of most parameters follow each table.

1Remember that the software sees uppercase as different from lowercase.
2A val ue of 0 means that no status will be sent.
3If 0, the connection will remain active continuously.
4Cont inuous r etries until connection is established.

Node Name

is displayed at the u pper right of the scree n when the device is being controlled by the

"local" keyboard and monitor. (If the local operator is controlling a remote Cabletron

frame relay access device, the R emote Control ID of that device will be displayed as the

local Node Name.)

Remote Control ID

is required if a remote Cabletron frame relay access device or async terminal will be

used to take control of th e local SmartSwitc h 1800 (via a physical or lo gical port in

the local device). The ID will be check ed again st the cal led addr ess fields of inc oming

Call Requests. The remote device can be a terminal connected to an async PAD port

on a remote Cabletron frame relay access device, or the remote device itself.

Table 4-1 Node Defaults Parameters

Parameter Valid Values Default Value
Node Name up to 8 ch aracters none
Remote Control ID 0–15 d igits none
Remote Control Pwd 0–15 characters 1remote
File Transf er ID 0–15 d igits none
File Transf er Pwd 0–15 characters 1ftran
Collecting Node ID 0–15 d igits none
Collecting Node Pwd 0–15 characters 1alarms
Primary Alarm O utput ID 1– 15 - di gi t addr ess none
Primary Alarm Outp ut Pwd 0–15 characters 1alarms
Secondary Alarm Output ID 1–15-di git add ress none
Secondary Alarm Output Pwd 0 –15 characters 1alarms
Collecting Node Y/N N
Max Congestion 1–50 (%) 50
Min Congestion 1–50 (%) 25
Periodic Status Timer 0–30 (min) 21
Line Idle Time r 0–65535 (s ec) 0 3
Alarm Autocall Timer 5–3600 (sec) 60
Alarm Max Retries 0–99 0 (no max) 4