7-4 Smart Switch 1800 4. 0 User Guide , Rev 0 1
2. Port Co nfigur ation ([A], [C], [A] from Main Menu) for the backup:
RLP: 0
RLP Port: 0
F Logical DCE: N (One end of the backup must be logical DTE, and t he other DCE.
Configuring the central site as l ogical DCE allows the line moni tor at that end to
track incoming status enquiries from the DTE end.)
O Additional Parameters
D Configure DLCI Parameters
DLCI ID: 17
I DLCI Backup Configuration
A Backup Group Number: 0
B Enable Backup Protocol?: N (Not necessary because protocol is
enabled in Frame Relay Backup Group record.)
E For Backup Use Only: Y
3. Frame Rela y Back up Gr oups C onfig urati on ( [A], [F], [B] from Main Menu):
Frame Relay Backup Group Number: 10
ARLP:0
C Port: 0
DDLCI:17
E WaitTimer: 60 (seconds) (or any number in r ange 0–65535; however , the setting
should be reasonably greater than the Switchover Timer on the primary {RLP 0/
Port 0/DLCI 17} being ba cked up)
F ProtEnab: Y
On Node 2, con f igure the fol l o w ing (as well as oth er parameters nece ssa r y f or op e r-ation):1. Port Co nfigur ation ([A], [C], [A] from Main Menu) for the primary:
RLP?: 0
RLP Port?: 0
O Additional Parameters
D Configure DLCI Parameters
DLCI ID?: 1 8
I DLCI Backup Configuration
A Backup Group Number: 0
B Enable Backup Protocol?: N
E For Backup use Only: N
2. Port Co nfigur ation ([A], [C], [A] from Main Menu) for the backup:
RLP?: 0
RLP Port?: 4
F Logical DCE: Y (One end of the backup must be logical DTE, and the other DCE.
Configuring the central site as l ogical DCE allows the line moni tor at that end to
track incoming status enquiries from the DTE end.)
O Additional Parameters
D Configure DLCI Parameters
DLCI ID?: 1 7
I DLCI Backup Configuration
A B ackup Group Number: 0
B En able Backup Protocol?: Y
E For Backup use Only: N